WHAT IS DYNAVAP?
DynaVap products are dry herb devices that provide exceptional flavor, while extending your flower reserve, and will last you a lifetime. Proudly made in the United States, they offer an innovative alternative to typical methods,
DynaVap devices require no batteries or electronics to work, but rather utilize any heat source (torch or induction heater), to heat a temperature indicating cap on a conduction/convection chamber.
NEED HELP DECIDING WHAT DEVICE IS BEST FOR YOU?
FAQ
Battery Free... how does that work?
DynaVap devices require no batteries or electronics to work, but rather utilize any heat source (torch or induction heater), to heat a temperature indicating cap on a conduction/convection chamber.
No Batteries. No Fuss.
Just pack, re-cap, heat, and enjoy!
Check out these awesome videos of founder George explaining the technicalities behind his device and how it works!
VIDEO: The Functionality of the DynaVap
VIDEO: How the Tip Works and the Purpose Behind the Different Tips
Learn more about how to heat the DynaVap here: How to heat a DynaVap Device
How do you heat a DynaVap device?
We recommend that you use a butane torch lighter for optimal results. To ensure even heating, apply the heat to the cap, away from the end, and rotate the device steadily until you hear/feel a click. Directly heating the end of the cap will cause it to click prematurely, causing reduced results.
DO NOT apply heat past the click.
Overheating will premenantley damage the cap.
With a torch lighter and a titanium tip, the typical heat-up phase takes 3-6 seconds and remains at vapor production temperature until the cool-down click about 30 seconds later. After the cool-down click, it is safe to begin another heating cycle. When using a soft flame lighter, the heat-up phase takes about 15 seconds. The stainless steel tip requires a longer heat-up time than the titanium tip.
VIDEO: Advanced Heating Tips
You can also heat your device with an Induction Heater.
VIDEO: Induction Heater Tips
How do you clean a DynaVap device?
To clean your device we suggest any cleaning solution of your choice, Isopropyl alcohol or just hot water and soap.
Let your device sit in the cleaning solution for a few hours and make sure to rinse it thoroughly with hot water. Use a cotton swab or pipe cleaners to help remove any additional buildup left in the device.
REMEMBER: DO NOT SOAK YOUR CAP OR ANY WOOD PARTS
TIPS:
- The more frequently you clean your device the easier it will be to clean.
- A clean device provides better taste
- If parts are hard to take apart run the device under hot water and use a twist and pull motion to pull pieces apart.
- Use a cotton swab to clean the inside of the cap.
- You do not need to remove the CCDs for cleaning, that is optional.
- Isopropyl alcohol can dry out the o-rings, remove rings before cleaning or use Dynawax to keep the rings moisturized to extend their life.
- All Metal Devices are dishwasher safe.
VIDEO: How to Clean The "M" by DynaVap
VIDEO: DynaVap Use & Care